From: Fernando Carvalho (fernando.cagica@t-online.de)
Date: Wed Dec 12 2007 - 11:10:22 ART
Hi,
I've seen a similar issue around one year ago. I had on my hub some
virtual-links (2) configured and after rebooting the router the neighbor
commands were no longer in the config. I was using a 3640 running
enterprise 12.4(8). Without the virtual-links there was no problem. I
downgraded to 12.4(5a) and was working fine. So i saw it as a bug and i
didn't think about it anymore.
HTH
-----Urspr|ngliche Nachricht-----
Von: nobody@groupstudy.com [mailto:nobody@groupstudy.com] Im Auftrag von
Alan Ewer
Gesendet: Mittwoch, 12. Dezember 2007 11:39
An: Cisco certification
Betreff: OSPF Neighbour config wont stick in config ?
Hi All
I have been pondering this little brain teaser ??
If I have a router configured with the following
router ospf 1
router id 1.1.1.1
network 1.1.1.0 0.0.0.255 AREA 0
neighbour 1.1.1.2
ok so far right !!
Int ser 0/0
ip address 1.1.1.1 255.255.255.0
frame map bla bla bla
ip ospf prio 0
and bingo the neighbour command disappears from the OSPF router config
... Anyone know why ???
Regds
Alan E
Brisbane, Aust
This archive was generated by hypermail 2.1.4 : Tue Jan 01 2008 - 12:04:30 ARST