From: shiran guez (shiranp3@gmail.com)
Date: Tue Dec 11 2007 - 08:54:14 ART
Host Communicate to Routers via IGMP and routers communicate to each other
via PIM.
PIM is only to set the Multicast Routers Path for sending Multicast traffic.
it is like you do not use Routing Protocol to communicate with your directly
attached router, you use arp or ipv6 icmp nd.
On Dec 11, 2007 10:17 AM, Sridhar Vaidyanathan <vsridhar83@gmail.com> wrote:
> Dear All,
>
> Is it required for enabling PIM on a fastethernet interface which is
> connected to Multicast receivers? Assuming that the router is a Stub
> Router
> and has one serial connection through which the router receives multicast
> feeds and PIM is enabled on the serial interface.
>
> Regards,
> Sridhar.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Shiran Guez MCSE CCNP NCE1 http://cciep3.blogspot.com http://www.linkedin.com/in/cciep3
This archive was generated by hypermail 2.1.4 : Tue Jan 01 2008 - 12:04:30 ARST