From: M_A_Jones@Dell.com
Date: Wed Dec 05 2007 - 11:30:05 ART
Lol, I was being sarcastic, but thank you sir.
Michael Jones
Network Engineer
Global Network Operations
Dell Inc. | Information Technology
W. 512.723.3268 | C. 512.966.6908
-----Original Message-----
From: Gupta, Gopal (NWCC) [mailto:gopal.gupta@hp.com]
Sent: Wednesday, December 05, 2007 4:49 AM
To: Darby Weaver; Jones, Michael A - Authorized Dell Representative;
mounir.ccieisa@gmail.com; asim.mz@gmail.com
Cc: ccielab@groupstudy.com
Subject: RE: bpdugaurd
Hi Michael,
Global means only the ports in the portfast will be affected globally
and not anyone else.
If you configure on every port then it can be enabled on that particular
port regardless of portfast
HTH
Gops
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Darby Weaver
Sent: Wednesday, December 05, 2007 14:07
To: M_A_Jones@Dell.com; mounir.ccieisa@gmail.com; asim.mz@gmail.com
Cc: ccielab@groupstudy.com
Subject: RE: bpdugaurd
Importance: Low
Works for me that way...
--- M_A_Jones@Dell.com wrote:
> If you enable BPDU Guard on every interface, isnt that Global???
>
> :)
>
>
> Michael Jones
> Network Engineer
> Global Network Operations
> Dell Inc. | Information Technology
> W. 512.723.3268 | C. 512.966.6908
>
> -----Original Message-----
> From: nobody@groupstudy.com
> [mailto:nobody@groupstudy.com] On Behalf Of Mounir Mohamed
> Sent: Tuesday, November 27, 2007 12:03 PM
> To: Asim Zafar
> Cc: Cisco certification
> Subject: Re: bpdugaurd
>
> Dear Asim,
>
> BPDU can not be enabled globally, but you can enable BPDUGUARD with
> portfast, in this case the command only effect all ports has portfast
> enabled.
>
> You can enable portfast per interface or globally by use
> SW1(config)#spanning-tree portfast default
>
> If you asked to enable BPDUGUARD on all access-ports you can do it
> with the below tow commands
>
> SW1(config)#spanning-tree portfast default SW1(config)#spanning-tree
> portfast bpduguard default
>
> You can verify it by:
>
> SW1#show spanning-tree interface f0/1 detail | inc
> Bpdu|portfast
> The port is in the portfast mode by default
> Bpdu guard is enabled by default
>
> Best Regards,
> Mounir Mohamed
>
> On Nov 27, 2007 2:03 PM, Asim Zafar
> <asim.mz@gmail.com> wrote:
>
> > Hi Techs,
> >
> >
> > If I implement BPDUGAURD on global config mode
> will it be implemented
> > on all access ports or it will be implemented on
> all ports regardless
> > access, trunk on the switch, if this is true then
> will we have to
> > configure them separately on all ports.
> >
> >
> > --
> > Thanks & Regards,
> >
> > Asim Zafar
> >
> >
>
This archive was generated by hypermail 2.1.4 : Tue Jan 01 2008 - 12:04:29 ARST