From: Fellenbaum, John D (john.d.fellenbaum@lmco.com)
Date: Mon Nov 19 2007 - 18:27:27 ART
On the gatekeeper issue the following debug and capture the output:
debug h225 asn1
debug gatek main 5
Remember to turn "term mon" on (term mon).
Try to make the call.
Post the results - The ARQs should show why it is failing.
HTH,
John
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
toonsh dosh
Sent: Monday, November 19, 2007 3:02 PM
To: ccielab@groupstudy.com
Subject: OT:MCU3515 with GK and Polycom H323 clients
Hi ,
Sorry for the OT. Was wondering if anyone has had much experience with
Polycom
V500 conference units registering as H323 devices on Gatekeeper. I have
been
able to get the devices to register fine on GK, I would like these
clients to
be able to dial one another directly via the GK. They are currently able
to
dial into the MCU no prblem. Should there been anything specific that
should
be allowed on the GK to allow the terminals to call one another ? Below
find
an excerpt of the config:
gatekeeper zone local zone1d test.com 172.18.2.9 zone local zone1a
test.com
zone local zone1b test.com
zone subnet zone1a 172.18.184.130/32 enable zone subnet zone1a
172.18.182.37/32 enable zone subnet zone1a 172.18.181.112/32 enable zone
subnet zone1a 172.18.180.101/32 enable zone subnet zone1a
172.18.184.209/32
enable zone subnet zone1a 172.18.182.157/32 enable
zone prefix zone1a 6712*
zone prefix zone1a 6037*
zone prefix zone1a 6730* zone prefix zone1a 6731*
zone prefix zone1a 6... gw-priority 10 CM_PUB_1 zone prefix zone1a 6...
gw-priority 9 CM_PUB_2
gw-type-prefix 1#* default-technology gw-type-prefix 81* hopoff zone1a
gw
ipaddr 172.18.2.10 1720 no use-proxy zone1a default inbound-to terminal
no
use-proxy zone1a default outbound-from terminal no use-proxy zone1b
default
inbound-to terminal no use-proxy zone1b default outbound-from terminal
no
use-proxy zone1c.ibm.com default inbound-to terminal no use-proxy
zone1c.ibm.com default outbound-from terminal no use-proxy zone1d
default
inbound-to terminal no use-proxy zone1d default outbound-from terminal
no
use-proxy zone1e default inbound-to terminal no use-proxy zone1e default
outbound-from terminal no use-proxy zone1f default inbound-to terminal
no
use-proxy zone1f default outbound-from terminal no use-proxy zone1g
default
inbound-to terminal no use-proxy zone1g default outbound-from terminal
no
use-proxy zone1h default inbound-to terminal no use-proxy zone1h default
outbound-from terminal no shutdown
So for now I would like a device in zone1a which is assigned DN 6712 to
call
6037 via the gatekeeper.
Thanks !
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:30 ART