From: Jonny English (redkidneybeans@gmail.com)
Date: Thu Nov 15 2007 - 19:50:52 ART
Yup, this is normal.
I always make sure I do a sh int status on the switch if I don't have
visibility of the other end.
In the lab, I would leave the ports shut till everything was
configured and then bring them up once I was happy everything's done.
On Nov 16, 2007 11:18 AM, CCIE <ccie@axizo.com> wrote:
> Once I configure Etherchannelling using channel-group 1 mode on, and delayed
> little bit in configuring the channeling on the other side, then I
> channeling would be down, and to over come that I have to shut and no shut
> the member of this Etherchanneling. Any advices to over come that.
>
> Regards,
>
> Amin
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:30 ART