From: V Shekhar (v.shekhar@yahoo.com)
Date: Sun Nov 11 2007 - 03:44:20 ART
This might be very basic question, but I could not find much in Cisco documentation.
what does "Security Level Default" mean in the following output?
Router#sh ip int serial 0/0
Serial0/0 is up, line protocol is up
Internet address is x.x.x.x
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Multicast reserved groups joined: 224.0.0.10
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is disabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is enabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF Fast switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
Thanks,
-sHekHar.
CCIE#17589/CISSP/RHCE.
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:29 ART