From: Con Spathas (con@spathas.net)
Date: Mon Nov 05 2007 - 08:52:04 ART
I think the command you're looking for is: 'sh mls qos interface <intf_id>
statistics'
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Alex
Steer
Sent: Monday, 5 November 2007 11:26
To: groupstudy
Subject: no output from "show policy-map interface" command on switch
Can someone check this configuration for me please. I didn't see any
packets/byte count for the output from the "show policy-map interface vlan
12" command but I can't remember if someone told me this was normal on a
switch. Anyway here is the config
Ip access-list ext ipv4
Permit ip any any
Class-map ipv4
Match access-group name ipv4
Policy-map test
Class ipv4
Set precedence 5
Vlan26
Interface vlan26
Service-policy test (note no ip address
configured for vlan 26, not layer 3)
Interface range fa0/2 - 8
Switch mode access
Switch acc vlan 26
The objective is to set all ipv4 traffic entering vlan26 with with a
precedence of 5. As stated above the "show policy-map interface vlan 26"
shows the policy-map above but no traffic matching class ipv4 nor
class-default.
If this is normal can someone suggest the reason and a possible way to prove
the configuration please?
Many thanks guys
Alex
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:28 ART