Re: Vg224 port as dot1q

From: Tarun Pahuja (pahujat@gmail.com)
Date: Sun Nov 04 2007 - 14:05:08 ART

• Next message: dara tomar: "Re: Basics- Etherchannel load-balancing"
• Previous message: Tarun Pahuja: "Re: find out eigrp AS that I need with debug"
• Maybe in reply to: viny gm: "Vg224 port as dot1q"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Viny,
        The VG224 is an analog gateway, you do not need Dot1q trunking for
it. Just put it in the voice vlan and make sure that the callmanager is
reachable so that it can register(configuration required). You would have to
enable QOS as per Cisco SRND.

HTH,
Tarun

On 11/4/07, viny gm <vinygm@gmail.com> wrote:
>
> Hi,
>
> Can i configure the vg224 fastethernet port as dot1q trunk or not ??
>
> if yes then how can i configure the voice and managment VLAN
>
> Regards
>
> Viny
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

• Next message: dara tomar: "Re: Basics- Etherchannel load-balancing"
• Previous message: Tarun Pahuja: "Re: find out eigrp AS that I need with debug"
• Maybe in reply to: viny gm: "Vg224 port as dot1q"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:28 ART