From: shiran guez (shiranp3@gmail.com)
Date: Thu Nov 01 2007 - 17:00:07 ART
I am going out of my mind to figure out this, it seam like this technology
do not want to go trough my head.
I already went trough the RFC and the Cisco DOC from univercd, but it is not
sinking in.
I understand how the Static 1 to 1 work, but the Dynamic I do not see how
can you set a range of address on one protocol and on the other protocol
without linking them one to one
for say I have IPv6 Network on one side and IPV4 on the other side and
NAT-PT between them, if i set a pool of IPv4 and a Prefix of /96 for the
IPv6 what address should I ping from the IPv6 to the IPv4 to reach a
specific node if it is not mapped how can he know where to go?
if some one have a better explanation and a working sample config I would
much appreciate it as I am pooling hare as we speak.
-- Shiran Guez MCSE CCNP NCE1 http://cciep3.blogspot.com http://www.linkedin.com/in/cciep3
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:27 ART