From: Scott Vermillion (scott_ccie_list@it-ag.com)
Date: Fri Oct 26 2007 - 23:06:25 ART
Hi WorkerBee,
Do you have the inline power supply installed in the 2811? IIRC, if you
didn't order that from the factory, it's an upgrade. It's probably been two
years back now, but I think I made that mistake once when the ISRs were
still pretty new. Didn't realize that I needed the additional power supply.
*IF* I remember this right, that ILPM in the below output is actually just
the inline power daughter card on your ESW module - it's not the actual
power supply that feeds it.
Have a look here:
http://www.cisco.com/en/US/products/ps5855/products_data_sheet0900aecd8016bf
0b.html
Sorry if I'm totally off base here but it's Saturday night so probably
responses will roll in slowly, figured I'd roll the dice. This is a very
vague memory from quite some time back...
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
WorkerBee
Sent: Friday, October 26, 2007 7:39 PM
To: Cisco certification
Subject: Configure 2811 HWIC-4ESW PoE
Anyone knows how to make this PoE card work? I tried connecting an IP
Phone to the port, it shows as down and not supply power to the IP
Phone. It is up when I connect to another switch. I am getting rid of
3560-PoE switches for space saving cards instead.
I am running 12.4(15)T1 image but under the interface configuration
mode, I don't see anything related to command 'power inline....'.
I am sure the card is recognize as follows:
Yaka#show inventory
NAME: "4 Port FE Switch on Slot 0 SubSlot 3", DESCR: "4 Port FE Switch"
PID: HWIC-4ESW , VID: VN/A, SN: FOC09453V5Y
NAME: "WIC/VIC/HWIC 3 Power Daughter Card", DESCR: "4-Port HWIC-ESW
Power Daughter Card"
PID: ILPM-4 , VID: VN/A, SN: FOC09454GU0
Yaka#show ip int brief
Interface IP-Address OK? Method Status
Protocol
FastEthernet0/3/0 unassigned YES unset up
down
FastEthernet0/3/1 unassigned YES unset up
down
FastEthernet0/3/2 unassigned YES unset up
down
FastEthernet0/3/3 unassigned YES unset up
down
This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:18 ART