From: Tarun Pahuja (pahujat@gmail.com)
Date: Wed Oct 24 2007 - 16:01:13 ART
Yup!
Only if they are redistributed into OSPF using the correct route-map.
If certain interfaces are not included as in your case, they will not
be redistributed. I thought earlier you were asking me the result on a
different switch since you mentioned Switch x.
Thanks,
Tarun
On 10/24/07, Khawar Butt <khawarb@khawarb.com> wrote:
> Hi Raul,
>
> The routes that are directly connected will always be seen as C
> (connected). You will see the O E2 on the other OSPF routers.
>
> Best Regards
> Khawar Butt
> CCIE#12353 (R/S , Security , SP , Voice)
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> juvenn@hotmail.com
> Sent: Wednesday, October 24, 2007 9:45 PM
> To: ccielab@groupstudy.com
> Subject: Redistribute connected ospf
>
>
> HI Guys need help
>
> SWx
> router ospf 1
> redistribute connected subnet route-map xx
>
> route-map xx
> match int yy
>
> when i do a show ip route on SWx , y i wont see
> Eo2 in my routing table , it only show connected
>
>
> Lab 19
>
> Thank alot
> Raul
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:18 ART