From: Alex Steer (alex.steer@eison.co.uk)
Date: Mon Oct 15 2007 - 18:08:58 ART
I'm doing a lab where I have been asked to configure a user that only
has access to shut no shut on a specific interface. Some of the
following has been put in automatically (I assume because I didn't
configure the "privilege interface level 1 no" command) I have tried
adding
priv configure all level 15 interface
priv configure level 1 interface serial 0/0
but doesn't work
privilege interface level 1 shutdown
privilege interface level 1 no shutdown
privilege interface level 1 no
privilege configure all level 15 interface range
privilege configure all level 1 interface
privilege exec level 1 configure terminal
privilege exec level 1 configure
privilege exec all level 2 show
anyway, when I login as the username test priv 1 I get loads of
commands...
...
ppp Start IETF Point-to-Point Protocol (PPP)
pwd Display current working directory
reload Halt and perform a cold restart
rename Rename a file
restart Restart Connection
resume Resume an active network connection
rlogin Open an rlogin connection
rsh Execute a remote command
sdlc Send SDLC test frames
send Send a message to other tty lines
setup Run the SETUP command facility
show Show running system information
slip Start Serial-line IP (SLIP)
squeeze Squeeze a filesystem
start-chat Start a chat-script on a line
systat Display information about terminal lines
tarp TARP (Target ID Resolution Protocol) commands
tclquit Quit Tool Command Language shell
tclsh Tool Command Language shell
telnet Open a telnet connection
terminal Set terminal line parameters
test Test subsystems, memory, and interfaces
tn3270 Open a tn3270 connection
etc etc etc...
when I conf t I don't get many commands
Router(config)>?
Configure commands:
call Configure Call parameters
default Set a command to its defaults
dss Configure dss parameters
end Exit from configure mode
exit Exit from configure mode
help Description of the interactive help system
interface Select an interface to configure
no Negate a command or set its defaults
when I issue an "interface" command I get
Router4(config)>interface ?
Async Async interface
BVI Bridge-Group Virtual Interface
CTunnel CTunnel interface
Dialer Dialer interface
Ethernet IEEE 802.3
Group-Async Async Group interface
Loopback Loopback interface
MFR Multilink Frame Relay bundle interface
Multilink Multilink-group interface
Null Null interface
Serial Serial
TokenRing IEEE 802.5
Tunnel Tunnel interface
Vif PGM Multicast Host interface
Virtual-Template Virtual Template interface
Virtual-TokenRing Virtual TokenRing
range interface range command
I only want to give access to serial0/0
Anybody suggest what rubbish I have produced please?
Thanks
Alex
This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:15 ART