From: Alexei Monastyrnyi (alexeim@orcsoftware.com)
Date: Mon Oct 15 2007 - 05:05:48 ART
Thanks mate.
This is for IOS SSL client, can't find the same for ASA...
asa(config-group-webvpn)# svc ?
config-group-webvpn mode commands/options:
compression Configure SVC compression
dpd-interval Configure the SVC DPD interval
enable Enable SVC
keep-installer Configure the SVC install enabler
keepalive Configure the SVC keepalive
none Disable SVC
rekey Configure the SVC rekey
required Enable and require SVC
A.
on 10/12/2007 8:13 PM Jason Guy (jguy) wrote:
> Alexei,
>
> Try using this command under the policy group definition:
>
> svc split exclude local-lans
>
> It will allow for the split tunneling to keep the route for the client's
> local LAN installed. At least, that is what I remember it being used
> for, it has been a while. :)
>
> Jason
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Alexei Monastyrnyi
> Sent: Friday, October 12, 2007 10:11 AM
> To: ccielab@groupstudy.com
> Subject: enabling Local LAN access for SSL VPN (SVC) clients / ASA 7.2.3
>
> Folks,
> I am just wondering if it is possible at all to enable it?
>
> In usual VPN client you just enable it on client side...
>
> Couldn't find anything about that in group policy.
>
> Shedding some light would be highly appreciated.
>
> A.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:14 ART