From: Scott Morris (smorris@ipexpert.com)
Date: Fri Oct 12 2007 - 14:20:50 ART
That would likely be a coding problem. :) If the coders simply say "change
the bit" then if it's a 1 already (locally assigned) then it would change it
to a 0. If the coders had said "make it a 1" then you wouldn't see a
change.
Amusing though. :)
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE-M
#153, CISSP, et al.
CCSI/JNCI-M/JNCI-ER
VP - Technical Training - IPexpert, Inc.
IPexpert Sr. Technical Instructor
A Cisco Learning Partner - We Accept Learning Credits!
smorris@ipexpert.com
Telephone: +1.810.326.1444
Fax: +1.810.454.0130
http://www.ipexpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of John
Sent: Friday, October 12, 2007 1:12 PM
To: ccielab@groupstudy.com
Subject: ipv6 eui-64 address
I'm wondering if this might be due to dynamips. I have f0/0 with a MAC
address of c200.0848.0000. That yeilds a eui-64 address of C000:8FF:FE48:0.
My understanding is that I should get an eui address of C200:8FF:FE48:0. not
C000:8FF:FE48:0 What happened to the 2. It shouldn't be the U bit because
that would change the value of C. Also any resources for IPv6 besides the
RFC's that you know of would be helpful
This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:14 ART