From: backbone systems (backbone.systems@gmail.com)
Date: Sun Sep 16 2007 - 03:16:36 ART
Hi,
I have some basic questions,
In IE Workbook Lab 1 - Task 1.5 the question asked that VLAN 102
should not traverse SW3 . I looked at the solution and it is fine
.But my pproach was a little bit different . What i would do is go to
the SW3 switch and remove VLAN 102 from all the trunks ,
than i will on the apposite side of each trunk and remove VLAN 102 .
For me this is the simplest approach . Why should i alter
VLAN trunks on each switch . For me in this question there is no need
to remove or allow anything on SW1.
CAn somebody comment on this ?Is my approach right?
Secondly if not specifically asked , can i build the bgp peerings
between neighbos over loopback ? Is it allowed ?
May be the system doesn't allow us to advertise some of the loopbacks
so it can be a problem too? Comment!!
Are we allowed to see and alter any config on BBs?
Regards,
Backbone
This archive was generated by hypermail 2.1.4 : Sat Oct 06 2007 - 12:01:12 ART