From: Andy Cole (Andy.Cole@foremostfarms.com)
Date: Mon Sep 10 2007 - 17:14:11 ART
sh ospf interface,
Check the timers, if they don't match, change one side to match the
other
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Carlos Trujillo Jimenez
Sent: Monday, September 10, 2007 3:06 PM
To: ccielab@groupstudy.com
Subject: OSPF neighbors not becoming adjacent over frame relay
I Have the followinf scenario in which Router A and RouterB are directly
connected each other over a NBMA frame relay cloud. Ospf is configured
in each router advertising its frame relay interface, Im trying to
establish adjacency between each other but, seems its not working with
the following
restrictions:
Restrictions:
Do not user neighbor command on any router.
Do not use interface level commands in router B.
Router A :
interface Serial0/0.125 multipoint
ip address 173.1.125.5 255.255.255.0
frame-relay interface-dlci 502
router ospf 1
log-adjacency-changes
network 173.1.125.5 0.0.0.0 area 0
Router B :
interface Serial0/0
ip address 255.255.255.0
encapsulation frame-relay
frame-relay map ip 173.1.125.5 205 broadcast
router ospf 1
log-adjacency-changes
network 173.1.125.2 0.0.0.0 area 0
In router A I configured the following, making it work, and both routers
become fully adjacent, but Im violating the restriction about "to not
use he neighbor command"
int ser 0/0
ip ospf network non-broadcast
ip ospf priority 255
routr ospf 1
neighbor 173.1.125.2
Any ideas about where should I go, or follow??
Remember it must work without the "neighbor" command in both routers.
This archive was generated by hypermail 2.1.4 : Sat Oct 06 2007 - 12:01:10 ART