From: Carlos Trujillo Jimenez (nergal888@hotmail.com)
Date: Mon Sep 03 2007 - 22:45:17 ART
Hi again friends...
Task 7.2 prompt to configure a full meshed IPV6 over IPV4 tunnels between
R1,R4 and R6.
Use the default encapsulation for these tunnels, and addressing in the
format 2001:187:X:AB::/64
Looking at the solution workbook, I see there is only a point to point
tunnel between R6 and R1, and another point to point tunnel between R6 and
R4.
But what about a point to point tunnel between R1 and R4?? I mean for the
"full mesh" it is asking the task. Instead of that it creates another tunnel
interface in both routers R4 and R1 with the same global adressing but
without tunnel source or destionation ipv4 based??
for those of you guys who understood the answer of the solution workbook,
how the full mesh tunneling (point-to-point)
I give a look to the univercd, but cant find any reference for these case.
http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/ipv6_c/sa_tunv6.htm
Thanks a lot, and Regards
This archive was generated by hypermail 2.1.4 : Sat Oct 06 2007 - 12:01:09 ART