From: Herbert Maosa (asawilunda@googlemail.com)
Date: Thu Aug 30 2007 - 16:45:11 ART
The exist map has to also match the route source, ie, the BGP neighbor that
is supposed to be sending you the prefixes that must exist.
Herbert.
On 8/30/07, ISolveSystems <support@isolvesystems.com> wrote:
>
> R6(as100) is connected to BB1(as54), BB3(AS54), and R3(AS100)
>
> "bgp inject-map SW1_LOOPBACK exist-map SW1_SW2_LOOPBACK" is issued on R6
>
> Any idea why 150.1.7.0 is not injected?
>
> Below is R6 config.
>
>
> Rack1R6(config-router)#do sh run | sec bgp
> router bgp 100
> no synchronization
> bgp log-neighbor-changes
> bgp inject-map SW1_LOOPBACK exist-map SW1_SW2_LOOPBACK
> neighbor 54.1.1.254 remote-as 54
> neighbor 54.1.1.254 remove-private-as
> neighbor 150.1.3.3 remote-as 100
> neighbor 150.1.3.3 update-source Loopback0
> neighbor 150.1.3.3 next-hop-self
> neighbor 204.12.1.254 remote-as 54
> neighbor 204.12.1.254 remove-private-as
> neighbor 204.12.1.254 route-map TO_BB3 out
> no auto-summary
>
> ip prefix-list SW1_LOOPBACK seq 5 permit 150.1.7.0/24
> ip prefix-list SW1_SW2_LOOPBACK seq 5 permit 150.1.0.0/20
>
> route-map SW1_SW2_LOOPBACK permit 10
> match ip address prefix-list SW1_SW2_LOOPBACK
>
> route-map SW1_LOOPBACK permit 10
> set ip address prefix-list SW1_LOOPBACK
>
>
> Rack1R6(config-route-map)#do sh ip bgp route-ma SW1_SW2_LOOPBACK
> BGP table version is 47, local router ID is 150.1.6.6
> Status codes: s suppressed, d damped, h history, * valid, > best, i -
> internal,
> r RIB-failure, S Stale
> Origin codes: i - IGP, e - EGP, ? - incomplete
>
> Network Next Hop Metric LocPrf Weight Path
> *>i150.1.0.0/20 167.1.58.8 0 100 0 65078 i
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Kindest regards, hm
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:13 ART