From: Hough, Earl (Earl.Hough@sarcom.com)
Date: Thu Aug 23 2007 - 11:42:33 ART
The original question was for the serial number of the ACS appliance,
not the ASA appliance.
Earl Hough
#16508
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Patrick Greene
Sent: Thursday, August 23, 2007 9:30 AM
To: 'Vivek Santuka'; 'Benjamin Hill'
Cc: 'Andrew Larkins'; 'CCIE Groupstudy'; 'Cisco certification'
Subject: RE: ACS Appliance serial number
Is the serial number shown with "show version" not the serial number of
the
chassis? (See below where is has the arrows <<<<<)
Cisco Adaptive Security Appliance Software Version 7.2(1)
Device Manager Version 5.2(1)
Compiled on Wed 31-May-06 14:45 by root
System image file is "disk0:/asa721-k8.bin"
Config file at boot was "startup-config"
colo-fw-01 up 29 days 11 hours
failover cluster up 29 days 11 hours
Hardware: ASA5510-K8, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash AT49LW080 @ 0xffe00000, 1024KB
Encryption hardware device : Cisco ASA-55x0 on-board accelerator
(revision
0x0)
Boot microcode : CNlite-MC-Boot-Cisco-1.2
SSL/IKE microcode:
CNlite-MC-IPSEC-Admin-3.03
IPSec microcode :
CNlite-MC-IPSECm-MAIN-2.04
0: Ext: Ethernet0/0 : address is 001a.6dea.48a0, irq 9
1: Ext: Ethernet0/1 : address is 001a.6dea.48a1, irq 9
2: Ext: Ethernet0/2 : address is 001a.6dea.48a2, irq 9
3: Ext: Ethernet0/3 : address is 001a.6dea.48a3, irq 9
4: Ext: Management0/0 : address is 001a.6dea.48a4, irq 11
5: Int: Not licensed : irq 11
6: Int: Not licensed : irq 5
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited
Maximum VLANs : 25
Inside Hosts : Unlimited
Failover : Active/Active
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Security Contexts : 5
GTP/GPRS : Disabled
VPN Peers : 250
WebVPN Peers : 2
This platform has an ASA 5510 Security Plus license.
Serial Number: NUMBER REMOVED FOR
SECURITY<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<LOOK
HERE<<<<<<<<<<<<<<<<<<<<<<<<<<<
Running Activation Key: REMOVE FOR SECURITY REASON
Configuration register is 0x1
Configuration last modified by enable_15 at 09:20:27.258 EST Thu Aug 23
2007
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Vivek Santuka
Sent: Wednesday, August 22, 2007 8:45 AM
To: Benjamin Hill
Cc: Andrew Larkins; CCIE Groupstudy; Cisco certification
Subject: Re: ACS Appliance serial number
Ben,
No way but to check the device physically for the Serial number. It will
not
be found anywhere else.
Regards,
Vivek
CCIE #17621 (Security)
On 8/22/07, Benjamin Hill <ibennybravo@gmail.com> wrote:
>
> Thanks, but i'm thinking it must be in the support dump .cab file
> somewhere...
>
> On 8/22/07, Andrew Larkins <Andrew.Larkins@btgroup.co.za> wrote:
> >
> > I had to strip the rack to get this since it was on the top of the
unit
> > in the middle of a rack with no access.
> >
> > Good luck
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> > Benjamin Hill
> > Sent: 22 August 2007 11:27 AM
> > To: CCIE Groupstudy; Cisco certification
> > Subject: ACS Appliance serial number
> >
> > Does anyone know where you find the serial number of an ACS
appliance?
> > Presuming that you dont have physical access to the device...
> >
> > Thanks,
> > B
> >
> >
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:12 ART