From: Avner Izhar (aizhar@ccbootcamp.com)
Date: Mon Aug 20 2007 - 11:33:28 ART
Hi,
Smells like cabling to me.
Have you tried replacing the cable between them? unidirectional
synchronization is not impossible.
Power cycle might change things as well, also send the full 'show interface'
output from R5, might be something there ...
-------------------------------------------
thanks,
Avner Izhar
CCIE#15999 (Voice), CCVP, CCSI# 31623
Technical Instructor
CCBOOTCAMP - A Cisco Sponsored Organization (SO)
Email: aizhar@ccbootcamp.com
Toll Free: 877-654-2243
Direct: +1-702-968-5100 = Outside the USA
FAX: +1-702-446-8012
YES! We take Cisco Learning Credits!
Register to win a free iPhone! http://www.ccbootcamp.com/iphone.html
________________________________
From: nobody@groupstudy.com on behalf of NITIN NITIN
Sent: Mon 8/20/2007 7:19 AM
To: ccielab@groupstudy.com
Subject: ethernet link not comming up
Hi ,
I have a issue which i strange for me
R5 fa1/0--------------F0/5 -SW1
R5#sh run int fa 1/0
Building configuration...
Current configuration : 72 bytes
!
interface FastEthernet1/0
no ip address
duplex full
speed 100
end
R5#sh isp inh it p inbrt br | i| i 1/10
/0
FastEthernet1/0 unassigned YES NVRAM up
down<<<
SW1#sh run int fa 0/5
Building configuration...
Current configuration : 110 bytes
!
interface FastEthernet0/5
switchport access vlan 2005
switchport mode access
speed 100
duplex full
end
SW1#sh ip int brief | i 0/5
FastEthernet0/5 unassigned YES unset up
up<<<<<<<<SW int up
If I shut interface on R5 =====
R5(config-if)#
*Aug 20 14:10:58.411: %LINK-5-CHANGED: Interface FastEthernet1/0, changed
state to administratively down
port on SW1 goes down 0-=-----
Aug 20 14:10:14: %LINK-3-UPDOWN: Interface FastEthernet0/5, changed state to
down
Regard
---------------------------------
Choose the right car based on your needs. Check out Yahoo! Autos new Car
Finder tool.
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:12 ART