From: shiran guez (shiranp3@gmail.com)
Date: Fri Aug 10 2007 - 16:43:36 ART
you can configure a loopback interface and do the loop back always will be
up!
ip unnumbered loopback x
On 8/10/07, Bit Gossip <bit.gossip@chello.nl> wrote:
>
> Experts,
> I run into this:
>
> http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapt
> er09186a00800ca72a.html
>
> "Configuring the ip address command within a virtual template is not
> recommended. Configuring a specific IP address in a virtual template can
> result in the establishment of erroneous routes and the loss of IP
> packets."
>
> Usually when I do PPPoFr I always configure the IP address on the the VT,
> where else could I configure it?
> Thanks,
> Luca.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Shiran Guez MCSE CCNP NCE1 http://cciep3.blogspot.com
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:10 ART