Multicast

From: Rafael Lupiano (rlupiano@gmail.com)
Date: Thu Aug 09 2007 - 11:40:06 ART

Next message: Horak Gregor, Bedag: "AW: PVLAN vs Protected port"
Previous message: ROBERT LEUGERS: "RE: OT: Cisco IOS developers are Star Wars fans?"
Next in thread: Bob Sinclair: "Re: Multicast"
Maybe reply: Bob Sinclair: "Re: Multicast"
Maybe reply: Ben: "Re: Multicast"
Maybe reply: ROBERT LEUGERS: "RE: Multicast"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello All,

I got a question related how to configure a multicast network using autorp
to provide fallback. I mean I need to configure R5 and R6 do be RP of
224.10.10.10 group, but If R5 is unavaiable R6 should take on. I've
configured as below:

R5
int lo0
ip add 192.168.5.1 255.255.255.0

access-list 10 permit 224.10.10.10

ip pim send-rp-announce lo0 scope 32 group-list 10

R6
int lo0
ip add 192.168.6.1 255.255.255.0

access-list 10 permit 224.10.10.10

ip pim send-rp-announce lo0 scope 32 group-list 10
ip pim send-rp-discovery lo0 scope 32

R3----R5 --- R6 ----- R3

However using above configuration the R6 assume because his IP address is
higher, how can I change this behavior on autorp?

Thanks,

Rafael

Next message: Horak Gregor, Bedag: "AW: PVLAN vs Protected port"
Previous message: ROBERT LEUGERS: "RE: OT: Cisco IOS developers are Star Wars fans?"
Next in thread: Bob Sinclair: "Re: Multicast"
Maybe reply: Bob Sinclair: "Re: Multicast"
Maybe reply: Ben: "Re: Multicast"
Maybe reply: ROBERT LEUGERS: "RE: Multicast"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:10 ART