From: Herbert Maosa (asawilunda@googlemail.com)
Date: Thu Aug 02 2007 - 19:59:23 ART
Hi,
You dont need OSPF area 0 in a single area implementation, even though it is
good practice. If you only have one area, it could any area ID of your
choice. Area 0 is only necessary for Inter-Area communication.
Herbert.
On 8/2/07, ISolveSystems <support@isolvesystems.com> wrote:
>
> Hello Experts,
> 3.1 OSPF - The is no mention of area 0 at all. I thought area 0 is always
> required. Have any one run into any issue with it?
>
> 3.10 Network Migration - At this point, there is no redistribution, yet.
> How
> does R3 in the RIP network know how to get to 148.1.68.0 in the OSPF
> network? This is being shown in the Task 3.10 verification of the solution
> guide.
>
> Thanks.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Kindest regards, hm
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:09 ART