From: Tony Schaffran (groupstudy@cconlinelabs.com)
Date: Thu Aug 02 2007 - 11:28:30 ART
That is most likely left over from a previous config.
Since the switch port is set to trunk mode, the access vlan line is not
used.
I see that a lot at customer sites.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Hash
Aminu
Sent: Thursday, August 02, 2007 7:07 AM
To: CCIE SG
Subject: Switch port access and Trunk port at the same time
Hello GS
found this in the one of the Data center center Core Switch I am working on,
the port is connected to a Cisco blade server switch.
what will be the motive of having access as well as trunk configs on the
same port
interface GigabitEthernet10/47
switchport
switchport access vlan 3
switchport trunk encapsulation dot1q
switchport mode trunk
no ip address
spanning-tree portfast
channel-group 2 mode on
end
TIA
Hash
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:09 ART