From: Ben (bmunyao@gmail.com)
Date: Wed Jul 18 2007 - 09:09:07 ART
Sergey,
1. Can't figure it out
2. spann portfast bpdufilter default
or
int f0/17
spann bpdufilter enable
3. Serhat's solutions ok
HTH
Ben
On 7/18/07, Serhat Aslan <serhatworks@gmail.com> wrote:
>
> Hi Sergey,
>
> 1. could be different vtp advertisement methods I mean different version
> probably version-2/3 downgrade it to version-1, (I haven't check it yet.)
> 2. bdguard seems ok. { if this command uses global level + portfast on the
> interface)
> 3.
> a-) create a different instance of a routing process, then distribute it
> on
> the main routing process. for example main routing process ospf-1, then
> create 2.ospf process as ospf-22, after all redistribute ospf-22 into
> ospf-1.
> b-) Also summarization can be use (area -range)
>
>
> -----
> Serhat Aslan
>
>
> On 7/18/07, Sergey <public@svlp.net> wrote:
> >
> > Could you help to answer some question from well known vendor book.
> >
> > Task1.Disable VTP Management Domain Name TLV in CDP advertisements?
> >
> > ??
> >
> >
> > Task2.Configure cat3550 such that if fa0/17 receive BPDU it should lose
> > its portfast status
> >
> > spanning-tree portfast bpduguard default ??
> >
> >
> >
> > Task3.Three methods to bring the full mask into OSPF from Loopback int
> >
> > I know only two
> >
> > 1)ip ospf net point-to-point
> > 2) redistribute connected
> > 3) ?
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:41 ART