From: Andy LaPorte (andy@cloud9.net)
Date: Wed Jul 18 2007 - 00:41:56 ART
I'm not sure about the flash part but to wonder if you have 16 megs of flash
and not a 32 meg flash.
As for the ram I believe you might need an upgrade bootrom.
http://cgi.ebay.com/NEW-BOOTROM-FOR-CISCO-2600XM-ROUTER-BOOT-2600XM-256_W0QQ
itemZ320138108348QQihZ011QQcategoryZ67292QQcmdZViewItem
This might also take care of the flash but I'm not sure.
Andy
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
CCIEDAVITO CCIEDAVITO
Sent: Tuesday, July 17, 2007 10:08 PM
To: Cisco certification
Subject: Re:2610xm router
looking for help for a 2610XM Router , I have upgraded the Router to the
following Memory.
I have a 32 MB Flash and 2 x128 MB Dram in the router but this is what
The router shows when I do a sh version. am suppose to see 48MB flash
because of 16MB on board flash according to the documentation.
>and 256 Dram any reason why it's not showing this.
>any help would be appreciatead Thank you.
>
>OM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE
>(fc1)
>
>R1 uptime is 5 minutes
>System returned to ROM by power-on
>System image file is "flash:c2600-is-mz.123-3e.bin"
>
>cisco 2610XM (MPC860P) processor (revision 0x300) with 124928K/6144K
>bytes of me
>mory.
>Processor board ID JAE08094NHU (3241649814)
>M860 processor: part number 5, mask 2
>Bridging software.
>X.25 software, Version 3.0.0.
>Primary Rate ISDN software, Version 1.1.
>1 FastEthernet/IEEE 802.3 interface(s)
>1 Serial network interface(s)
>2 Channelized T1/PRI port(s)
>1 ATM AIM(s)
>2 Voice FXS interface(s)
>32K bytes of non-volatile configuration memory.
>32768K bytes of processor board System flash (Read/Write)
>
>Configuration register is 0x2102
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:41 ART