From: Vladislav Yezhergin (vlad_ezh@hotmail.com)
Date: Sun Jul 15 2007 - 04:49:13 ART
2 new interface cards - 1-port HWIC (HWIC-1FE) and as a 2-port HWIC
(HWIC-2FE) - are available now for 1841/2800/3800 routers. Minimum level of
IOS is 12.4(11) XJ.
The Fast Ethernet ports on the HWICs should have the same characteristics
and features as the onboard Ethernet interfaces for the platforms. Along
with Layer 3 connectivity, such as per-port access control lists (ACLs),
routing, and IP addressing, these HWICs provide equivalent functions to
onboard Fast Ethernet routed ports.
See more -
http://www.cisco.com/en/US/products/ps5854/products_data_sheet0900aecd80581fe6.html
Vladislav Yezhergin
----- Original Message -----
From: "Mike Kraus (mikraus)" <mikraus@cisco.com>
To: "Chamara Peris" <dimsyboy@gmail.com>; "Cisco certification"
<ccielab@groupstudy.com>
Sent: Sunday, July 15, 2007 2:32 AM
Subject: RE: Confusion on HWIC-4ESW
> The HWIC-4ESW's ports cannot be configured as Layer 3 ports (you can't
> issue no switchport). Now, you can assign the ports to vlans, and of
> course you can assign IPs to the SVIs associated with those VLANs.
>
> The 1841 does not support the addition of any additional routed layer
> ports.
>
> See here for configuration of the HWIC-4ESW:
> http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_
> chapter09186a00804554c7.html
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Chamara Peris
> Sent: Saturday, July 14, 2007 5:16 PM
> To: Cisco certification
> Subject: Confusion on HWIC-4ESW
>
> Hi Group,
>
> I am planning to add hwic-4esw to one of my routers. But I am not
> exactly sure how this interface can configure for IP address. Cisco site
> indicates it's a L2 switching ports. All I want is to increase my
> Ethernet ports on
> 1841 by one more (comes with two Fast ethernet ports). By using
> hwic-4esw can it be configured with all 4 ports with 1 ip address
> (which gives me the additional ip address I required) or can it be
> configured with ip address to each port?.
>
>
> Or any other module for 1841 to achieve this?.
>
> Thanks
> CP
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:41 ART