From: Filyurin, Yan (yan.filyurin@eds.com)
Date: Sun Jul 01 2007 - 16:59:16 ART
Wouldn't you also need ip local policy routing command, to send locally
originated traffic through Loopback? In fact would we even need NAT at
all? In other words, traffic is originated locally, it gets policy
routed to next-hop of Loopback interface and it would come sourced from
that. I am still not sure about the last part. I will have to lab it
up.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Mike Kraus (mikraus)
Sent: Sunday, July 01, 2007 3:45 PM
To: Antonio Soares; Bhaskar Sivanesan; ccie forum
Subject: RE: traceroute
I just tried this, source is still physical... Tried just doing ip nat
enable (with NVI) to see if router would magically figure it out too,
but to no avail.
Have you gotten this to work?
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Antonio Soares
Sent: Sunday, July 01, 2007 2:30 PM
To: 'Bhaskar Sivanesan'; 'ccie forum'
Subject: RE: traceroute
None since the traffic is sourced from the router itself.
_____
From: Bhaskar Sivanesan [mailto:bas_bharath@yahoo.com]
Sent: domingo, 1 de Julho de 2007 20:25
To: Antonio Soares; ccie forum
Subject: Re: traceroute
Thanks Antonio, which will be the "ip nat inside" interface in this
case.
cheers
----- Original Message ----
From: Antonio Soares <amsoares@netcabo.pt>
To: Bhaskar Sivanesan <bas_bharath@yahoo.com>; ccie forum
<ccielab@groupstudy.com>
Sent: Sunday, July 1, 2007 8:19:13 PM
Subject: RE: traceroute
The answer is NAT:
Example config:
!
access-list 102 permit icmp any any port-unreachable
access-list 102 permit icmp any any ttl-exceeded
!
ip nat inside source list 102 interface Loopback0 overload
!
!
interface Ethernet1/0
ip nat outside
!
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Bhaskar Sivanesan
Sent: domingo, 1 de Julho de 2007 19:58
To: ccie forum
Subject: traceroute
Hi group
How do we change the source IP address in the ICMP TTL exceeded reply
messages.
Like, when I am doing a traceroute, I want the reply to be sourced from
the
respective router's loopback ip address rather than the interface
address?
is there any way to do it?
thanks
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:39 ART