From: Capt.Spock (capt.spock@gmail.com)
Date: Sat Jun 23 2007 - 19:58:39 ART
Why does the BW show different values in sh int and sh ip eigrp topology
command for loopback? As a result the metric value does not match to
interface value but to the second one.....If I change the value to any thing
it does change both places but by default the values are different??
R1#sh int loopback 0
Loopback0 is up, line protocol is up
Hardware is Loopback
Internet address is 171.16.1.1/24
MTU 1514 bytes, *BW 8000000 Kbit*, DLY 5000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation LOOPBACK, loopback not set
R1#sh ip eigrp topology 171.16.1.0 255.255.255.0
IP-EIGRP (AS 100): Topology entry for 171.16.1.0/24
State is Passive, Query origin flag is 1, 1 Successor(s), FD is 128256
Routing Descriptor Blocks:
0.0.0.0 (Loopback0), from Connected, Send flag is 0x0
Composite metric is (128256/0), Route is Internal
Vector metric:
*Minimum bandwidth is 10000000 Kbit
* Total delay is 5000 microseconds
This archive was generated by hypermail 2.1.4 : Sun Jul 01 2007 - 17:24:51 ART