From: Dave Schulz (dschulz@skyline-ats.com)
Date: Wed May 30 2007 - 16:40:48 ART
The key is to make sure that any unused DLCIs are NOT in the frame map. So,
if you do a show frame-relay map command....this should detail only what is
to be used in the lab. So, depending on the specified network command type,
you will want to use the no frame-relay inverse-arp. HTH
Dave Schulz
dschulz@skyline-ats.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of CCIE
19999
Sent: Monday, May 28, 2007 8:35 PM
To: ccielab@groupstudy.com
Subject: Unused DLCI
Folks,
I am wondering about the unused DLCIs in the frame relay section in the lab.
I assume, there could be some unused DLCIs in the lab.
Suppose, if there is no mention about the unused DLCIs how do we actually
ascertain if we need to use NO FRAME-RELAY INVERSE-ARP IP <dlci> command?
Can someone shed some light into it?
Thanks in advance,
Shine
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:22 ART