From: Mohammad Saeed (mzsaeed@gmail.com)
Date: Mon May 28 2007 - 22:00:12 ART
Good, but Scott, does that mean that those two interfaces will be
authenticating? If Yes, then would those be using 0 as key?
Thanks,
Mohammad Zahed Saeed
On 5/28/07, Scott Morris <smorris@ipexpert.com> wrote:
> MD5 authentication will work just fine without setting up a key. If you
> look at "show ip ospf interface" you'll see that it's using "key 0" which is
> the NULL authentication key.
>
> Perfectly fine.
>
> HTH,
>
>
> Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE
> #153, CISSP, et al.
> CCSI/JNCI-M/JNCI-J
> IPexpert VP - Curriculum Development
> IPexpert Sr. Technical Instructor
> smorris@ipexpert.com
> http://www.ipexpert.com
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Mohammad Saeed
> Sent: Monday, May 28, 2007 7:00 PM
> To: Router Girl
> Cc: Cisco certification
> Subject: Re: how to configure ospf authentication
>
> Unless you assign the key, which is basically password how authentication
> going to work?
>
> Mohammad Zahed Saeed
>
> On 5/28/07, Router Girl <ciscoroutergirl@gmail.com> wrote:
> > Does anyone know how to configure OSPF with the strongest
> > authentication and without using keys?
> >
> > ______________________________________________________________________
> > _ Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:22 ART