From: anthony.sequeira@thomson.com
Date: Wed Apr 11 2007 - 18:34:46 ART
The following features are not supported in Transparent Mode:
* DYNAMIC ROUTING PROTOCOLS
* NAT
* IPv6
* DHCP Relay
* QoS
* Multicast
* VPN Termination for Through Traffic
Anthony J Sequeira
#15626
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
nem chua
Sent: Wednesday, April 11, 2007 4:55 PM
To: Cisco certification
Subject: OSPF over ASA transparent mode
Hello,
Anyone ran this before? When I had the asa firewall run ospf it works
fine. I tried running asa firewall in transparent mode, access-list
wide
open for ip any any, and ospf any any. All traffic pass fine, but ospf
will
not form an adjacency and stuck in INIT state. If I plug the router on
each
end directly, bypassing the firewall it works fine. Any idea?
This archive was generated by hypermail 2.1.4 : Tue May 01 2007 - 08:28:35 ART