From: Todd, Douglas M. (DTODD@PARTNERS.ORG)
Date: Thu Apr 05 2007 - 10:08:04 ART
Laurence:
<ip split-horizons> is primarily for rip since there is no process id assigned
to it. While you enable split-horizons for eigrp via the eigrp <PID>.
You should find the information here:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hirp_r/rte
_rih.htm#wp1117913
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hirp_r/rte
_eih.htm#wp1114486
DMT
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
huangyinxiao@gmail.com
Sent: Thursday, April 05, 2007 8:50 AM
To: ccielab@groupstudy.com
Subject: IP split-horizon
Hi all,
When configure eigrp on frame-relay link, ip split-horizon should be enabled.
But, I don't know which command should I use. I know there two commands can
enable ip split-horizon. One is "ip split-horizon" and the other is "ip
split-horizon eigrp 100". So which one should I use. I've tried "ip split
horizon eigrp 100" on routers, but when I do show run, it does not exist.
Can anyone tell me which one should use?
Thanks
Cheers,
Laurence
This archive was generated by hypermail 2.1.4 : Tue May 01 2007 - 08:28:34 ART