From: Marut S@MS@DCTH-BKK (S@MS@DCTH-BKK)
Date: Mon Apr 02 2007 - 11:42:03 ART
Hi Dan,
I think nei -- will add ( but not change ) the update to be
unicast.
Best Regards,
Marut Siriwangso
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Dan C
Sent: Tuesday, 20 March, 2007 6:35 PM
To: Huang Laurence
Cc: Ivan; Cisco certification
Subject: Re: How to minimise RIP's update traffic on routers
Hi Laurence,
Depends on which type of interfaces you are using. rip trigged works
only on
virtual template interface... You will need to set a rip domain and
check
debug ip rip using the options mentioned before....
passive interface default --- the router will not send any updates on
that
link but it will still listen and accept routes in..
nei --- will change the update from multicast address into unicast
address
and so on...
Also, there are few tricks on interface connected to the rip network
too....
Cheers,
Dan
On 3/20/07, Huang Laurence <huangyinxiao@gmail.com> wrote:
>
> Thanks Ivan.
>
> You make me more clear on these.
> If you configure below, it can reduce the updates. That's right.
>
> router rip
> pass def
> neig x.x.x.x
>
> But do I still need enable "rip trigged"? It can also help to minimise
the
> rip updates.
>
> Thanks again.
>
> Laurence
>
>
>
> On 20/03/07, Ivan <ivan@iip.net> wrote:
> >
> > You can easily check this by debugging rip. You need to achieve
> consistncy
> > FIB
> > with less update packets (including Lo's)
> >
> > Pay attention on update to Loopback interfaces. Such as question
state
> > minimize update traffic on _ROUTER_
> >
> > router rip
> > pass def
> > neig x.x.x.x
> >
> > On Tuesday 20 March 2007 01:48, huangyinxiao@gmail.com wrote:
> > > Hi group,
> > >
> > > I confuse on the question that "how to minimise the RIP's update
> traffic
> > on
> > > one of RIP routers(R2)?" when I am doing the lab execises. What
does
> > this
> > > question real mean? I have four solutions described as following,
and
> I
> > > don't know which answers is correct.
> > >
> > > 1. passive interface need to be configured
> > > 2. rip trigged need to be configured
> > > 3. neighbor command to transfer to unicast
> > > 4. summary
> > >
> > > what answers can be meet the reqirement? Or anyother
understandings
> > about
> > > the question?
> > >
> > > Thanks for your any reply!
> > >
> > > Regards,
> > >
> > > Laurence
> > >
> > >
>
This archive was generated by hypermail 2.1.4 : Tue May 01 2007 - 08:28:34 ART