Re: How to Elect RP as Primary in Auto-RP with lowest RP

From: Radioactive Frog (pbhatkoti@gmail.com)
Date: Sun Apr 01 2007 - 05:41:17 ART

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/himc_c/chap05/mcbbasic.htm#wp1134342

Sparse Mode with Auto-RP: Example

The following example configures sparse mode with Auto-RP:

ip multicast-routing

 ip pim autorp listener

 ip pim send-rp-announce Loopback0 scope 16 group-list 1

 ip pim send-rp-discovery Loopback1 scope 16

 no ip pim dm-fallback

 access-list 1 permit 239.254.2.0 0.0.0.255

 access-list 1 permit 239.254.3.0 0.0.0.255

 .

 .

 .

 access-list 10 permit 224.0.1.39

 access-list 10 permit 224.0.1.40

 access-list 10 permit 239.254.2.0 0.0.0.255

 access-list 10 permit 239.254.3.0 0.0.0.255

 Sparse Mode with Anycast RP: Example

On 4/1/07, lalit gupta <lalit.tech@gmail.com> wrote:
>
> Hi GS,
>
> I have few queries here,
>
> 1) If i have two routers first is 1.1.1.1 and 2nd is 1.1.1.2. By default
> 1.1.1.2 will be elected as RP in auto-RP process because of highest RP
> address. Is there any way i can make 1.1.1.1 as a primary RP instead of
> 1.1.1.2. If yes , then what is the command ?
>
> 2) How to enable traps for RMON event ?
>
> If we use SNMP-SERVER ENABLE TRAP (it enables trap for everyone) but i
> want to enable trap only specific to RMON.
>
> Could any one plz help me with this?
>
> Thanks and Regards
> Lalit Gupta
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

This archive was generated by hypermail 2.1.4 : Tue May 01 2007 - 08:28:34 ART