From: maureen schaar (maureen.schaar@gmail.com)
Date: Fri Mar 30 2007 - 05:18:49 ART
Definitely! Make sure there are no dynamic mappings or mappings to
0.0.0.0 if they tell you that dynamic mappings are not allowed. If
your lab is preconfigured, then you may need to perform a reload to
accomplish this (you should always reload all your routers after
config is done anyway).
Maureen
On 3/30/07, Shamin <ccie.xpert@gmail.com> wrote:
> Hi all,
>
> I am trying to remove the unwanted DLCI's from the interface s0/0 of R2. Did
> the no frame-relay inverse-arp command. But still the DLCI's are shown
> mapping to 0.0.0.0 . After a restart of the router, these entries will be
> removed. In the actual lab, do we have to make sure that these entries are
> not shown in the sh frame map output if they specifically say that, no other
> DLCI's other than the ones specified should be used. If it is so, is there a
> method to do this without restarting the routers?.
>
> Rack1R2#sr int s0/0
> Building configuration...
>
> Current configuration : 192 bytes
> !
> interface Serial0/0
> ip address 157.1.123.2 255.255.255.0
> encapsulation frame-relay
> frame-relay map ip 157.1.123.1 203
> frame-relay map ip 157.1.123.3 203
> no frame-relay inverse-arp
> end
>
>
>
>
> Rack1R2#sh frame map
> Serial0/0 (up): ip 0.0.0.0 dlci 213(0xD5,0x3450)
> broadcast,
> CISCO, status defined, inactive
> Serial0/0 (up): ip 0.0.0.0 dlci 205(0xCD,0x30D0)
> broadcast,
> CISCO, status defined, inactive
> Serial0/0 (up): ip 0.0.0.0 dlci 204(0xCC,0x30C0)
> broadcast,
> CISCO, status defined, inactive
> Serial0/0 (up): ip 0.0.0.0 dlci 201(0xC9,0x3090)
> broadcast,
> CISCO, status defined, active
> Serial0/0 (up): ip 157.1.123.1 dlci 203(0xCB,0x30B0), static,
> CISCO, status defined, active
> Serial0/0 (up): ip 157.1.123.3 dlci 203(0xCB,0x30B0), static,
> CISCO, status defined, active
>
> Rack1R2(config)#do sh frame pvc | in DLCI
> DLCI = 201, DLCI USAGE = LOCAL, PVC STATUS = DELETED, INTERFACE =
> Serial0/0.1
> DLCI = 203, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0/0
> DLCI = 204, DLCI USAGE = LOCAL, PVC STATUS = DELETED, INTERFACE =
> Serial0/0.1
> DLCI = 205, DLCI USAGE = LOCAL, PVC STATUS = INACTIVE, INTERFACE = Serial0/0
> DLCI = 213, DLCI USAGE = LOCAL, PVC STATUS = DELETED, INTERFACE =
> Serial0/0.1
> Rack1R2(config)#
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Apr 01 2007 - 06:35:53 ART