From: Adam (thehick777@gmail.com)
Date: Tue Mar 27 2007 - 19:24:19 ART
Could the ppp encap conflict with the "ip ospf net" statement?
Just guessing. Haven't tested it yet.
----- Original Message -----
From: "Keith Bizzell" <mkbcoolman@gmail.com>
To: "Cisco certification" <ccielab@groupstudy.com>
Sent: Tuesday, March 27, 2007 3:09 PM
Subject: OSPF neighbor problem
> Maybe I'm sleep deprived, but I can't figure this out to save my life.
> HELP!!!
>
>
> interface Serial0/1/0
> ip address 163.1.13.1 255.255.255.0
> encapsulation ppp
> ip ospf network non-broadcast
> ip ospf priority 100
> ppp authentication pap
> ppp pap sent-username Rack1R1 password 0 CISCO
> end
>
> Rack1R1(config-router)#do show ip os int s0/1/0
> Serial0/1/0 is up, line protocol is up
> Internet Address 163.1.13.1/24, Area 1
> Process ID 1, Router ID 150.1.1.1, Network Type NON_BROADCAST, Cost: 64
> Transmit Delay is 1 sec, State DR, Priority 100
> Designated Router (ID) 150.1.1.1, Interface address 163.1.13.1
> No backup designated router on this network
> Timer intervals configured, Hello 30, Dead 120, Wait 120, Retransmit 5
> oob-resync timeout 120
> Hello due in 00:00:22
> Supports Link-local Signaling (LLS)
> Index 1/4, flood queue length 0
> Next 0x0(0)/0x0(0)
> Last flood scan length is 0, maximum is 0
> Last flood scan time is 0 msec, maximum is 0 msec
> Neighbor Count is 0, Adjacent neighbor count is 0
> Suppress hello for 0 neighbor(s)
>
> Rack1R1(config-router)#neigh 163.1.13.3
> OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
> networks
> Rack1R1(config-router)#
>
> Why would I see this?
>
> Thanks in advance - Keith
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Apr 01 2007 - 06:35:53 ART