From: ian (iyux2000@gmail.com)
Date: Tue Mar 27 2007 - 03:50:51 ART
Bit Gossip,How are you#!
Today, i found another insteresting issue. On some router, i can not ping the multicast router. But when i configure sparse-dense-mode on loopback0, everything starts working fine. I have no idea about what i've done.
======= 2007-03-27 06:19:49 What you've mentioned in your letter#:=======
>I had the same problem yesterday:
>- very simple hub'n spoke topology
>- spokes join the group, hub pings the group, one spoke replies only
>first couple of pings, while other spoke always replies.
>Could not figure out what was wrong, but then when I enable process
>switching for multicast 'no ip route-cache' it started to work fine.
>Maybe some cef issue?
>Thanks,
>Luca.
>
>On Sun, 2007-03-25 at 23:13 -0400, iyux2000@gmail.com wrote:
>> Hi, group
>> When i'am testing BSR multicast configuration, i did everything that i think it is correct according to the Cisco Documentation. However, when i was pinging some multicast source address, it works actually at the first or second time. And then pinging is failed, however, if i stopping pinging and wait for 30-60 seconds, i pinged again, it was secussful. Did you pals experenice the same problem before?
>> Any recommendations are highly appreciated.
>>
>>
>> Have a nice day.
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
= = = = = = = = = = = = = = = = = = = =
!!!!!!!!!!!!!!!!Have a nice day.
!!!!!!!!!!!!!!!!ian
!!!!!!!!!!!!!!!!iyux2000@gmail.com
!!!!!!!!!!!!!!!!!!!!2007-03-27
This archive was generated by hypermail 2.1.4 : Sun Apr 01 2007 - 06:35:53 ART