From: Ben Zheng (bzheng8989@yahoo.com)
Date: Sun Mar 18 2007 - 14:52:24 ART
Dishan
When packet leaves from PE3, the source will be the ip address of it's WAN interface. This address shall be visable from PE4. Can you check it to see if this subnet is on PE4 routing table?
Ben
----- Original Message ----
From: Dishan Gamage <dishanlg@gmail.com>
To: Cisco certification <ccielab@groupstudy.com>
Sent: Saturday, March 17, 2007 11:29:15 PM
Subject: SP question InterAS-VPN reacability issue!!!
Hi Group
I have the following setup configured.
CE2----PE3---------PE1-------ASBR1--------ASBR2-----PE-4-----CE6
CE2---loopback 2.2.2.2
CE6-- loopback 6.6.6.6
CE2--PE3 routing protocol is eigrp 100
PE4--CE6 is static
VPNv4 is enabled between ASBR1 & 2 ( with bgp )
I can see the loopback of CE2 on PE4, vrf but I cannot ping it...
also on CE2 i can see the loopback of CE6, but cannot reach it
either.........( each others routes are seen in both CE2 & CE6)
when i do a trace from CE2 to CE6, trace stops after PE3 wan interface, also
when i trace from CE6 to CE2 it stops after PE4
but i have reachability from PE1 to PE4 & visa-versa via bgp ipv4 ,
Pls comment, I ll be happy to post configs if needed............
Tks in advance
Dishan
In cef it show correct...........
From PE4 i am able to see the route
This archive was generated by hypermail 2.1.4 : Sun Apr 01 2007 - 06:35:51 ART