From: Jeff Mullan (jmullan78@gmail.com)
Date: Tue Mar 13 2007 - 02:51:59 ART
So just a followup so that I can sleep well the night before the result :)
If the question says do not use inverse arp, and I have a situation where
main interface is "without" IP address, I dont need to explicitly turn
in-arp off on the main interface ( and still get full points ) :) ?
Actually, the workbook I am following does disable inver arp on main
interface even though it is without an IP address.
-JM
On 3/10/07, Digital Yemeni <digital-yemeni@hotmail.com> wrote:
>
> yes if there is no IP address on the interface there will be no
> inverse-arp
> anyway!
>
> I guess Brian Dennis is tired already! so, i do it on behave of him ;-)
>
>
>
> Best Regards,
>
> Digital
>
> ------------------------------------------------------------------------------------------------------------------
>
>
>
> ***********************************************************************************
> *.* You'll NEVER succeed as a "CCIE" until you LOVE Cisco MORE than your
> sleep! *.*
>
> ***********************************************************************************
> I've not slept for the past 5 years and I'm expected to be busy for the
> next
> 57 years + The 5 CCIEs preparation adds on that a bit. Therefore, please
> be
> concise on your email. Thank you!
>
>
>
>
>
> >From: "Jeff Mullan" <jmullan78@gmail.com>
> >Reply-To: "Jeff Mullan" <jmullan78@gmail.com>
> >To: "Cisco certification" <ccielab@groupstudy.com>
> >Subject: FR IN-ARP
> >Date: Sat, 10 Mar 2007 03:33:51 -0800
> >
> >Folks,
> >In the scenario below, I dont have an IP address on the main interface
> and
> >using sub-Interface for IP address configuration. I dont see a point here
> >disabling in-arp on s2/2 even though the questions specifically says "
> dont
> >dynamically learn arp " . Am I correct in my understanding ?
> >This scenario is from one of the vendors WB and they have explicitly
> >disabled inarp on the main interface. Any thoughts ?
> >Thanks,
> >-JM
> >
> >
> >
> >interface Serial2/2
> > no ip address
> > encapsulation frame-relay
> >end
> >
> >
> >R3#sh run int s2/2.1
> >Building configuration...
> >
> >%Serial2/2.1 :Header-Compression not configured on interface
> >Current configuration : 117 bytes
> >!
> >interface Serial2/2.1 point-to-point
> > ip address 141.1.123.3 255.255.255.0
> > frame-relay interface-dlci 302
> >end
> >R3#
> >
> >_______________________________________________________________________
> >Subscription information may be found at:
> >http://www.groupstudy.com/list/CCIELab.html
>
> _________________________________________________________________
> FREE pop-up blocking with the new MSN Toolbar - get it now!
> http://toolbar.msn.click-url.com/go/onm00200415ave/direct/01/
This archive was generated by hypermail 2.1.4 : Sun Apr 01 2007 - 06:35:51 ART