From: Darby Weaver (darbyweaver@yahoo.com)
Date: Sat Feb 17 2007 - 08:33:36 ART
Where is you reflector interface?
Did I miss it? 6:31 am and a long nite of studying...
Try it with this and see if helps.
Too lazy to config it...
Later
Darby
--- san <san.study@gmail.com> wrote:
> Hello All,
>
> I have a need to setup RSPAN and looking to see how
> to sniff.
>
>
> Sw1=======Sw2
>
> Vlans per Switch
> SW1 => vlan 65,66,67,68,69,70, 999
> SW2 => vlan 65,66,67,68,69,70, 999
> SW1 and SW2 are 3750
>
> I have a sniffer drop at SW2 1/0/43 and need to
> sniff all the vlans at both
> the switches to this port.
>
> Configuration below can only brings the source vlan
> 65,66,67,68,69,70 on SW1
> to SW2 port 1/0/43 .
>
> Problem is Traffic from SW2 vlans (65,66,..70) are
> not sniffed to sniffer
> port through configuration 1.
> - Switch doesnot allow to add additional source
> commands like "source vlan
> or source interface".
>
> I havenot tried the configuration option2 below.
> Would this work or Any
> other method to solve this ?
>
>
> Configuration 1:
> -------------------------
> SW1:
> -------
> vlan 999
> rspan
>
> monitor session 1 source vlan 65 - 72
> monitor session 1 destination remote vlan 999
>
> SW2:
> --------
> vlan 999
> rspan
>
> monitor session 1 source remote vlan 999
> monitor session 1 destination interface Gi1/0/43
>
>
>
> Configuration 2:
> -------------------------
> SW1:
> -------
> vlan 999
> rspan
>
> monitor session 1 source vlan 65 - 72
> monitor session 1 destination remote vlan 999
>
> SW2:
> --------
> vlan 999
> rspan
>
> monitor session 1 source remote vlan 999
> monitor session 1 destination interface Gi1/0/43
>
> monitor session 2 source vlan 65 - 72
> monitor session 2 destination remote vlan 999
>
>
> --
> Thanks & Rgds
> SAN
>
>
This archive was generated by hypermail 2.1.4 : Thu Mar 01 2007 - 07:38:47 ART