Re: created vlans not shown in sh run

From: Varun Gulati (varun.gulati@gmail.com)
Date: Mon Jan 29 2007 - 17:42:15 ART

• Next message: anthony.sequeira@thomson.com: "RE: Simple question about the new Cisco CCIE LAB blueprint"
• Previous message: Filyurin, Yan: "RE: Multiple route redistribution points"
• Maybe in reply to: Sharifi, Reza: "created vlans not shown in sh run"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Ya you can't see them if the Switch is in Server and client mode.
AS info is in Vlan.dat file in flash.

Change it to transparent and you can see it in sh run.

On 1/30/07, Sharifi, Reza <Reza.Sharifi@gdit.com> wrote:
>
> Hello Group,
>
>
>
> Is there a command to implement on Cisco switches, so you can see the
> vlan(s) you created in sh run?
>
> Example: Vlan 1 vlan 2
>
> But you can't see them in sh run or sh config
>
> They only way I can view them is by using sh vlan
>
> Devices are 2950G and 3560G
>
>
>
> Thanks,
>
> Reza
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

• Next message: anthony.sequeira@thomson.com: "RE: Simple question about the new Cisco CCIE LAB blueprint"
• Previous message: Filyurin, Yan: "RE: Multiple route redistribution points"
• Maybe in reply to: Sharifi, Reza: "created vlans not shown in sh run"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:57 ART