From: Scott Morris (swm@emanon.com)
Date: Fri Jan 19 2007 - 16:29:06 ART
Because this command is not used for PVCs on our DTE side of things...
Per the DocCD, under Usage Guidelines:
"You must enable Frame Relay policing on the incoming interface, using the
frame-relay policing interface command, before you can configure
traffic-policing parameters.
You must enable Frame Relay switching using the frame-relay switching global
command before the frame-relay tc command will be effective on switched
PVCs.
When the CIR is greater than 0, Tc is equal to Bc divided by the CIR. "
So, although it sounds really nice, all it would do for us is "document"
this on our interface so we didn't need to re-calculate things every time we
looked at it! But otherwise, no effect.
HTH,
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE
#153, CISSP, et al.
CCSI/JNCI-M/JNCI-J
IPexpert VP - Curriculum Development
IPexpert Sr. Technical Instructor
smorris@ipexpert.com
http://www.ipexpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Robert Watson
Sent: Friday, January 19, 2007 2:18 PM
To: ccielab@groupstudy.com
Subject: Frame-relay TC value
Why do we have to keep figuring out the tc with the formula when you can
statically set it with the frame-relay tc command?
This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:57 ART