From: srdja blagojevic (srdja1@pexim.co.yu)
Date: Tue Jan 16 2007 - 10:07:18 ART
Salman,
try to put same VTP password on both switches, and try to sync them then.
hth,
Srdja
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Salman Abbas
Sent: Tuesday, January 16, 2007 12:59
To: Cisco certification
Subject: Strange VTP problem
Hi GS,
I'm pulling my hair as I cant figure out why VTP is not getting synchronized
between two directly connected 3550 switches. SW1 is server and SW2 is
client. I've created a few VLANs on SW1 but they are not being propogated to
SW2 via VTP. Domain name is VTP01 and no vtp password has been configured.
From my experience the MD5 digest of two switches must be the same if they
are to exchange VLANs. In this case however, I cant get them to be the same
even though both switches have identical vtp configuration.
The show vtp status command output for the switches is as follows: PLEASE
help guys!!!!
SW1(config)#do sh vtp sta
VTP Version : 2
Configuration Revision : 0
Maximum VLANs supported locally : 1005
Number of existing VLANs : 12
VTP Operating Mode : Server
VTP Domain Name : VTP01
VTP Pruning Mode : Disabled
VTP V2 Mode : Disabled
VTP Traps Generation : Disabled
MD5 digest : 0x15 0xD2 0x16 0x8B 0x2B 0xAB 0x98 0x4B
SW2(config)#do sh vtp sta
VTP Version : 2
Configuration Revision : 0
Maximum VLANs supported locally : 1005
Number of existing VLANs : 5
VTP Operating Mode : Client
VTP Domain Name : VTP01
VTP Pruning Mode : Disabled
VTP V2 Mode : Disabled
VTP Traps Generation : Disabled
MD5 digest : 0x9F 0x69 0x29 0xFF 0xA1 0x48 0xB4 0xAB
Thanks in advance!!!!
Regards,
Salman
This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:56 ART