From: david robin (robindavi@gmail.com)
Date: Sun Jan 14 2007 - 17:23:32 ART
Dear all,
I have a question,
is there is any different between FRTS and MQS and , I know all the
parameters are the same but when i show the interface in FRTS the queuing
is FIFO but in MQC it is weighted fair on the serial interface, does that
make any difference
on the MQC below:
Rack1R6#sh int s 1/0
Serial1/0 is up, line protocol is up
.
.
.
Queueing strategy: weighted fair
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1158 kilobits/sec
5 minute input rate 1000 bits/sec, 1 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
but in case FRTS
Rack1R6(config-if)#int s 1/0
Rack1R6(config-if)#frame-relay interface-dlci 51
Rack1R6(config-if)#frame-relay traffic-shaping
Rack1R6(config-if)#do sh int s 1/0
Serial1/0 is up, line protocol is up
.
.
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 2 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:56 ART