From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Sat Jan 13 2007 - 14:30:20 ART
Using the Cisco IOS Command-Line Interface
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hc
f_c/ch10/cfh100.htm#wp1001965
Designating a Keystroke as a Command Entry
You can configure the system to recognize a particular keystroke (key
combination or sequence) as command aliases. In other words, you can set
a keystroke as a shortcut for executing a command. To enable the system
to interpret a keystroke as a command, use the either of the following
key combinations before entering the command sequence:
Keystrokes
Purpose
Ctrl-V or Esc, Q
Configures the system to accept the following keystroke as a
user-configured command entry (rather than as an editing command).
HTH,
Brian Dennis, CCIE4 #2210 (R&S/ISP-Dial/Security/SP)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
JM HotMail
Sent: Saturday, January 13, 2007 9:01 AM
To: 'Dishan Gamage'; 'Cisco certification'
Subject: RE: vtp password or enable password with ''?" charactor.....
I believe it is ESC-Q with CRT/secureCRT. Jean-Marc
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Dishan Gamage
Sent: Saturday, January 13, 2007 5:10 AM
To: Cisco certification
Subject: vtp password or enable password with ''?" charactor.....
Hi Group
may b a silly question ................
i tried to set the vtp password for a switch (vtp password command)
the password should be "12?aB?76"
switch doesn't take the password correcty b cos of charractor " ? " in
the
actual password
has any one experianced this before ??
whats the soln ?
reg
Dishan
This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:56 ART