From: Scott Morris (swm@emanon.com)
Date: Sat Jan 06 2007 - 13:09:18 ART
I'd probably look on the DocCD under the Command Reference... Perhaps going
to the IP Routing Protocols section and looking at EIGRP Commands.
Perhaps a Ctrl-F for "hop" or "hop count" would help things out there? :)
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hirp_r
/rte_eih.htm#wp1000064
Sometimes it good to figure out what keywords are important to help you
search for things. Nobody will ever memorize all of the commands. Even
after all these years, I still look things up (most likely 'cause I killed
too many brain cells at an earlier age, but that's a different story!
(grin))
HTH,
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE
#153, CISSP, et al.
CCSI/JNCI-M/JNCI-J
IPexpert VP - Curriculum Development
IPexpert Sr. Technical Instructor
smorris@ipexpert.com
http://www.ipexpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Bit
Gossip
Sent: Saturday, January 06, 2007 10:39 AM
To: groupstudy
Subject: EIGRP hop count
Hi group,
is there any way to manipulate hop count in eigrp?
I noticed that offset-list manipulates the composite metric but NOT
hop-count!
Thanks,
Luca
This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:55 ART