From: Edward Norton (doubleccie@yahoo.com)
Date: Wed Jan 03 2007 - 16:16:32 ART
thanks for the input ,in fact i have seen this link before i post
the problem is that when i type the menu item 322873738 followed by # ..it keep asking me for the password ( IVR says p a s s w d) ...so it seems asking for the password to reset to factory default .
i think this procedure is for SCCP load and the ATA i have is SIP one ..there must be something else then
any tips will help :)
I
"Hough, Earl" <Earl.Hough@sarcom.com> wrote:
Ed,
Check out the following link on CCO:
http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/ataadmn/sccp3_
0/sccpach3.htm#wp1094880
Look at the section entitled "Resetting the Cisco ATA to Default Factory
Values". This definitely should work to reset the device if it has been
locked down by Vonage or if the passwords are forgotten.
HTH
Earl Hough
CCIE #16508
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Edward Norton
Sent: Wednesday, January 03, 2007 4:53 AM
To: ccielab@groupstudy.com
Subject: OT: ATA 186 password recovery
folks ;
I have an ATA 186 and im trying to connect via the web but it keep
asking for password ..i tried few links on the Cisco site to recover the
password via the IVR menu ..but again this does not work
im not sure what is the load on this device ...is there any tips ?
Regards
This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:55 ART