From: Azhar Ali (dr_azha@yahoo.com)
Date: Sun Dec 24 2006 - 10:19:27 ART
Hi Group,
I have 2811 running software version
c2800nm-spservicesk9-mz.124-10a.bin.
Outgoibg calls - Ok, No issues.
Incoming calls - Calls are not connected at all.. At this stage, if I dial an
outside number and then dial in again then the issue is resolved. Also calls
are being disconnected intermittently.
Below is the brief current
configuration. I`ll highly appreciate any advice.
voice-card 0
dspfarm
!
!
voice call convert-discpi-to-prog
!
voice service voip
h323
h225 timeout
setup 10
modem passthrough nse codec g711alaw
!
!
voice translation-rule 1
rule 1 /^09/ /1/
rule 2 /3430/ /100/
rule 3 /4410/ /100/
rule 4 /1252/
/100/
rule 5 /9380/ /100/
rule 6 /0384/ /100/
!
!
voice translation-profile
isdn-incoming
translate called 1
!
!
interface BRI0/2/0
no ip address
isdn
switch-type basic-net3
isdn overlap-receiving
isdn tei-negotiation
first-call
isdn point-to-point-setup
isdn incoming-voice voice
isdn
calling-number 90309
isdn sending-complete
!
!
voice-port 0/2/0
compand-type
a-law
cptone IE
!
dial-peer voice 92 pots
tone ringback alert-no-PI
translation-profile incoming isdn-incoming
destination-pattern 9T
direct-inward-dial
port 0/2/0
!
dial-peer voice 900 voip
preference 1
destination-pattern 1..
session target ipv4:10.0.2.2
incoming called-number
.
dtmf-relay h245-alphanumeric
codec g711alaw
no vad
Thanks in advance !
Azhar
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:39 ART