RE: RIP Metric change

From: אלי קושרובסקי (eli_kosh@netvision.net.il)
Date: Thu Dec 21 2006 - 19:03:49 ART

• Next message: Bit Gossip: "IEWB R&S Ver4"
• Previous message: ccie anees: "Eigrp bandwidth percent"
• Maybe in reply to: Liu_Liao: "RIP Metric change"
• Next in thread: prashant shukla: "Re: RIP Metric change"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I dont think this is possible - I can think of a scenario where such a
config can create a routing loop ...

Eli
 

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Liu_Liao
Sent: Wednesday, December 20, 2006 5:41 PM
To: Darby Weaver
Cc: 'ccielab groupstudy'
Subject: Re: RIP Metric change

Hi All
Thanks reply
1.1.2.0 120/4
If I want change 120/4 to 120/3 and how to do?

Richard

 
Darby Weaver ??:

>Use an offset list would be one way.
>
>
>--- Liu_Liao <liu_liao@yahoo.com.tw> wrote:
>
>
>
>>Hi All
>>
>>R1 <--> R2 <->R3
>>R1 get route table is
>>1.1.1.0/24
>>1.1.2.0/24
>>1.1.3.0/24
>>R1 and R2 run RIPv2
>>If I want configure on R2 and show ip route folloeing 1.1.2.0 120/3
>>
>>How to do??
>>
>>Tks!
>>
>>
>>
>>
>_______________________________________________________________________
>
>
>>Subscription information may be found at:
>>http://www.groupstudy.com/list/CCIELab.html

• Next message: Bit Gossip: "IEWB R&S Ver4"
• Previous message: ccie anees: "Eigrp bandwidth percent"
• Maybe in reply to: Liu_Liao: "RIP Metric change"
• Next in thread: prashant shukla: "Re: RIP Metric change"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:38 ART